The pack came out more messy than I could imagine.

Yeeesh... Not anywhere near perfection

Yes, maybe I rushed it in the past two weekends.  Yet it is finished and now finally I test all connections before plugging it into the Pint. 

I had trouble keeping the group of six in alignment (that would be the top of the frame).  The make shift jig slipped while pressing the spot welder against them and the whole thing is quite twisted.

For now, I'll just continue with the tests and make sure the voltage order is correct and detectable through the plug. 

Cells #6 and #7 were connected from underneath instead of from above due to more space from below and the module clearance at the near divider was open at that point.

The source connector at the XT60 side does currently read 53 volts and therefore, no shorts...obviously.